Ask us about our INDUSTRY-LEADING 36,000 mile / 3-year warranty on our repairs!

Call now:

1-801-352-0986

Integrity First Automotive

8020 S. 1300 W.
West Jordan, UT  84088

Volkswagen 2.8L VR6

This is engine work on a 2002 Volkswagen Jetta VR6.  The VR6 engine is a brilliant engine design where the cylinders are in a 'V' design but the engine still only uses one cylinder head, instead of the traditional two heads that all other V engines use.

The 'R' in VR6 stands for 'narrow angle'.  Rumor is that VW jumped on this when the patent for this design expired.  The VR6 first saw production in the VW Corrado, followed by the GTI.  It recieved mass acclaim from the automotive news press and was considered by many to have saved the hot-hatch market segment that was basically invented by VW's first GTI - marketed in the US as the Rabbit GTI.

Here's the cylinder head - it isn't much bigger than an inline four cylinder:

VW VR6 Cylinder Head

Here's the engine block:

VW VR6 Engine Block

Note here that it is mounted transversely in the Jetta and again isn't much bigger than a four-cylinder.

 

A common service challenge with the VR6 is the timing gear.  This engine came apart because it had blown a head gasket from overheating.  However, like many VR6's with some milage on it, the timing chain guides were damaged.  If left unrepaired this would likely have caused timing chain failure and severe engine damage.

Here's a shot of the old and new rear guide:

VW VR6 Broken Timing Chain Guide

 

The complication with this engine design is that the timing chain is on the REAR of the engine.  So, to service the chain requires removal of the transmission.

 

Here's the new guide in place.  Notice that the timing gear consists of two chains - an upper (hanging loose in this picture) and the lower.

VW VR6 Timing Chain and Guide

Notice the new (clean) upper chain guide installed?  The really unfortunate part about this design is that, to replacd this guide, the lower chain cover has to come off the engine.  This requires removal of the transmission and either the flex plate (automatic transmission cars) or the clutch and flywheel (manual transmission).

 

Here's some shots of this engine going back together.

 

Head Gasket Installed:

VW VR6 Head Gasket

Head installed - notice the camshafts and the timing chain.

VW VR6 Camshafts

Here's the head before installation of the intake manifold:

VW VR6 Intake Removed

 

Here's the lower intake installed (with Fuel Injectors):

VW VR6 Lower Intake

 

Here's the Upper Intake Installed (Starting to look like an engine again!):

VW VR6 Upper Intake

 

This particular VR6 is the simplier of the two main designs that VW made.  This one only has one camshaft per cylinder bank so it is technically a single-overhead-cam design (even though it 'looks' like a double cam design).  VW also made a double overhead cam version where the engine has a total of four camshafts.

Other derivatives of this engine design include the W design where two cylinder heads, both using narrow-angle pistons, are used.  This design made it into the W8 Passat.  There are also exotic W16 engines and other high power designs made by VW.

 


ASE Certified Technicians on-staff International Association of BMW Service Professionals BBB Member Member:  International Automotive Technicians' Network Member:  West Jordan Chamber of Commerce

 

 

/
Integrity First Automotive – Salt Lake City Auto Repair
8020 S 1300 West Salt Lake City, Utah 84088 Phone: (801)352-0986